Arlington Residential Glass Replacement

No. That haze is inside the sealed airspace between the two panes, so no amount of cleaning from either side will reach it. It means the insulated unit's perimeter seal has failed and moisture has entered. The unit has to be replaced — but here is the part most homeowners are relieved to hear: the window frame and sash almost always stay. We replace the glass unit only, which costs far less than a full window replacement and requires no exterior work or repainting.

In the large majority of Arlington homes, just the glass. Frame replacement is only necessary when the frame itself is rotted, corroded, badly warped or structurally compromised — or when you are deliberately upgrading the whole window for other reasons. If your frames are sound and the problem is fogging, cracking or breakage, glass-only replacement is the right repair. We tell you which situation you are in at the measure, before you commit to anything.

It depends where the window is. Building code designates certain spots hazardous locations that require safety glazing: glass in or within 24 inches of a door, glass in bathrooms near tubs and showers, glass at the bottom of stairways, and large panes close to the floor. In those spots the replacement must be tempered or laminated and permanently marked. Elsewhere, standard annealed glass is fine and costs less. We identify which applies at the measure — it matters at resale, when inspectors look for the mark.

The installation itself is usually well under an hour per opening. The waiting is in fabrication, because tempered and insulated units are made to your exact measurements rather than pulled off a shelf. Standard clear glass in a common size is often a few business days. Tempered, low-E insulated and oversized units typically run one to two weeks. If the opening is broken, we secure it the same day so you are not waiting on fabrication with a hole in the house.

On west- and south-facing windows, usually yes. North Texas has a long, punishing cooling season, and a low-E coating blocks a large share of solar heat gain while keeping the view clear — it does not darken or tint the glass noticeably. Since you are already paying for the labor and the unit, the incremental cost of adding low-E is modest and it typically pays back through reduced cooling. On shaded north-facing windows the benefit is much smaller.

Yes, and North Texas gives us plenty of practice. We photograph the damage, provide an itemized scope and quote in the format carriers expect, and can coordinate directly with your adjuster. Emergency board-up is normally covered as loss mitigation. Get it secured promptly — delaying can raise questions about secondary damage that complicate the claim.

Regularly. Bring or send us a template, or we can measure the piece in your home. Glass is cut to shape in 1/4″ or 3/8″ thickness with your choice of polished, beveled or seamed edges, and tempered where the application calls for it — which we generally recommend for dining tables and anywhere children are around. Corners can be radiused rather than left sharp.

It varies with size, glass type and access. A small annealed pane in a ground-floor window is at the low end. A large low-E insulated unit in a second-storey opening is considerably more, because both the glass and the labor scale up. Because every opening differs, we measure first and then give you an itemized written quote covering glass, labor and disposal — no charge for the estimate and no obligation to proceed.