McKinney Mirror Replacement Services

The spotting itself cannot be reversed — that is desilvering, where the reflective backing has corroded, and it is permanent. But the piece is often still worth saving. We can supply antiqued and distressed mirror that reads period-appropriate rather than jarringly new, cut to fit the existing frame, so you keep the frame and the character while getting a mirror that actually works. Send us a photo of the piece and its frame and we can usually advise before visiting.

Usually, though it takes patience. Builder mirrors are typically held with corner clips plus construction adhesive, and the adhesive is the problem — pulled carelessly it takes the drywall paper with it. We cut the mirror free in sections and work the adhesive off the wall rather than levering the panel. Some minor wall repair is occasionally unavoidable and we say so upfront. If the new mirror covers the same footprint it becomes irrelevant anyway.

Seamed means the sharpness is ground off but the edge is not finished for display — correct and cheapest where the edge sits behind a frame. Polished is a smooth, flat, clear finished edge and the standard for a frameless mirror on a wall. Beveled adds an angled border around the perimeter, usually half an inch to an inch wide, which catches light and reads more traditional — often the right choice in a period home.

Moisture getting behind the mirror over time, which corrodes the reflective backing. It is worth diagnosing the cause before replacing, because a bathroom with weak ventilation will do exactly the same to the new mirror within a few years. In older McKinney homes an inadequate or absent extractor fan is frequently the real culprit, and sometimes the genuine fix is ventilation rather than glass.

Yes, and it is worth insisting on. Gym, studio and fitness room mirrors should be safety-backed — a film laminated to the back that holds fragments together if a panel is struck. Standard mirror breaks into long heavy shards that fall, which in a room where people are moving weights or dancing is a serious hazard. The cost difference is modest; the risk difference is not.

Larger than most people expect, but weight becomes the limit rather than the glass. A 1/4″ mirror weighs roughly three and a half pounds per square foot, so a big panel gets heavy fast — heavy enough to need a crew and proper mechanical support rather than adhesive alone. For full walls we normally plan multiple panels with seams positioned where they read least, which is safer to install and easier to replace if one is damaged.

Yes, but measurements must be exact and right the first time. All cutting and drilling happens at fabrication — mirror cannot be modified on site without breaking it. We measure fixture and outlet positions precisely during the measure visit. If you are planning to move a light or add an outlet, do it before we measure rather than after the mirror is cut.

It scales with square footage, edge finish, backing and access. A standard vanity mirror with polished edges sits at the low end. A beveled custom shape or an antiqued piece cut to an existing frame is more. A safety-backed full gym wall is a considerably larger project, mostly because of area and handling. We never compromise on the fairness of our pricing or the dependability of our craftsmanship, and estimates are free.